Activation of Autointerval IRQ by TRAP #15 function
Page 1 of 1

Author:  tasscaff [ Wed Nov 19, 2008 12:51 pm ]
Post subject:  Activation of Autointerval IRQ by TRAP #15 function


currently i am developing a multitasking picokernal for hardware based on the M68000. I use Easy68K for software development and simulations. My taskscheduler is activated every 10ms by interrupt. To simulate this i use the Autointerval function in the hardware window. But this needs a lot of manual work and is not very handy. If i can activate this by a TRAP #15 function and handle it like a timer source, the simulation would run similar to the real system and makes my work easier.

best regards

Author:  profkelly [ Fri Jan 23, 2009 5:58 pm ]
Post subject: 

Added to Sim68K v4.4.5

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group